DS chip is commonly used as DS RTC module which comes with a 32 kHz crystal and on-board battery backup all in a small SIP. Part Number: DS, Maunfacturer: Maxim, Part Family: DS, File type: PDF, Document: Datasheet – semiconductor. DS The DS trickle-charge timekeeping chip contains a real-time clock/ calendar and 31 bytes of static RAM. It communicates with a microprocessor via.

Author: Kalkis Brara
Country: Gambia
Language: English (Spanish)
Genre: Career
Published (Last): 5 May 2017
Pages: 37
PDF File Size: 1.93 Mb
ePub File Size: 14.74 Mb
ISBN: 774-7-43465-336-3
Downloads: 39969
Price: Free* [*Free Regsitration Required]
Uploader: Zulujinn

Arduino on other Chips. See the datasheet for full specifications and a circuit. Other schematics use two 22pF with the crystal.

If a byte is read, the addres is written first. The code below contains basic interface functions for the DS That would result in bad clock data. A crystal of The playground is a publicly-editable wiki about Arduino.

Cheap modules with the DS and DS have often problems with the crystal and the voltage. You are strongly advised to use a DSwhich is very reliable and accurate and needs only a battery to run the crystal is inside the DS To prevent ratasheet, the DS has a buffer to store the clock dds1302. The standard date and time functions like: The DS can be easily connected to the Arduino. For more info pleae look at this Forum Post. Sources for Electronic Parts.


Arduino Playground – DS

The chip has 31 bytes of ram. This is a cheap module with the DS The most used name is “3-wire interface”.

The last clock pulse of the address using the rising edge is also the first clock pulse of the data to read using the falling edge. It has a Leap-Year compensation from up to for a value of Some schematics on the internet have pull-up resistors on the three interface lines.

I was noted that the code could be improved.

The data in this ram will get lost if the Arduino is off, and the battery or supercap gets empty. The Year ‘0’ isand not or During reading, the clock could rollover. So the code has to detect that condition to prevent an extra clock pulse. The most used date and time functions for the Arduino: That way the check for the 7th bit is not needed, since dstasheet line is always released.


Use it with Arduino 1. That buffer can be read in d1302 single communication session, called a “burst” mode.

For the name of a month, this page contains many languages: At this moment there is no official library for date and time functions for the Arduino. The three pins for the interface should avoid to use the internal pull-up resistors of the Arduino. This circuit has pull-down resistors which are an extra, in many cases they are not needed. Board Setup and Configuration. The page at maxim for the DS with all information and datasheet: Related Vatasheet and Initiatives.

Datasheet «DS1302»

The Year data of the DS is only two digits That is also wrong. The Vcc1 is for a battery or a rechargable battery or a supercap. They often datasueet work very well.